4CH DC 5-32V voltage-free ZigBee + RF controller

ZigBee DC driver for the Ewelink application

Power supply - 5V Micro USB or 7-32 V AC/DC with support for RF 433.92 MHz EV1525 remote controls fixed codes

RF 433.92 MHz remote controls sold separately. Look for our other offers.

Compatible with ZigBee 3.0 gateways - TUYA, eWelink, etc.

Compatible with Zigbee2MQTT in Home Assistant (Zigbee controller used is Conbee II, but also works on CC2531) It is visible as a quad switch. Each of the 4 switches can be controlled separately.

3 operating modes: monostable (pulse), bistable (self-locking), with time delay.

Works with Google Home, Amazon Alexa through compatible gateways.

Attention! In case of problems with the operation of the device in the TUYA application, make sure that the ZigBee 3.0 gateway has the latest software version.

The device is intended to control other electronics and does not have a housing.

Dimensions: 79x74x18 mm

Own power consumption: <1 W

Connectivity standard: ZigBee 3.0

Standby current: 80 mA

Receiver: RF 433.92 MHz fixed codes EV1527

Input voltages: 5V DC or 5V/7-32V DC

3 LEDs that indicate working mode, WiFi status, relay status

Operating conditions: -30°C to 75°C, humidity less than 95%

Security mechanisms: WEP/WPA-PSK/WPA2-PSKNC: Normally closed relayCOM: CommonNO: Normally open

ATTENTION. Depending on the delivery, the appearance of the printed circuit board, relay or arrangement of elements on the board may differ.

Basics of the ZigBee protocol:

The ZigBee protocol operates on the 2.4 GHz frequency, which propagates well in buildings

ZigBee connectivity is MESH connectivity, which means that each ZigBee device with full L+N power works as a signal amplifier for other devices. If a remote sensor does not have communication with the ZigBee gateway, it is enough that it has radio communication with another ZigBee device with full L+N power that has communication with the gateway (up to a maximum of 3 devices). The devices work in a mesh chain of connections, which ensures reliability and certainty of the connection

Devices using the ZigBee protocol connect to the control panel in 0.2 seconds in the event of a state change, and WiFi needs about 5 seconds to connect to the network after a state change. ZigBee devices have a huge advantage when it comes to automating smart rules

On a WiFi network with 25 devices you will start to experience network issues. You can easily add over 50 devices to the ZigBee hub

The ZigBee gateway and ZigBee devices allow for much wider and longer storage of parameter data and device history. Door opening history, temperature history, motion detection history saved months ago

ZigBee communication consumes very little energy, which gives a long battery life.

Set contains:

ZigBee+RF voltage-free 4CH DC Ewelink Tuya controller

User manual

Packaging

Product code: SZ169R