2CH DC5-32V relay Wifi+RF

Sonoff DC 2 Channel Wifi controller with support for RF433MHz remote controls

Power supply - 5 V Micro USB or, 7-32 V AC/DC

3 operating modes: monostable (pulsed), bistable (self-locking), with delay time. Application: The switch is perfect for controlling lighting, gates, actuators, door control, button signaling, computer control, access control, voltage-free control - heating furnaces, device control powered by 230 V Works with Google Home, Amazon Alexa, IFTTT Connect to your gate module in place of the hand button contacts and you have a smartphone-controlled garage door. The device is designed to control electronics and does not have a housing. Application: The switch can be used for access control, turning on a computer, garage door, etc. Input power supply: AC/DC 7-32 V or USB 5 V/500 mA

Two interfaces input: 7-36 V or micro USB 5 V

Output: 0 V - NO/COM/NC x2

Channels: 2

Maximum load per relay: 10 A

RF433.92 MHz receiver codes constant EV1527

Operating mode: monostable/bistable/variable

Input voltages: 5V DC or 5V/7-32V AC/DC

LEDs 3 LEDs that indicate the operating mode, WiFi status , relay status.

Operating conditions -30° C to 45° C, humidity less than 95%

Wi-Fi standard 2.4 GHz

Security mechanisms WEP/WPA-PSK/WPA2-PSK

Dimensions: 104 x 33 x 17 mm'NC': Normally closed relay 'COM': Common 'NO': Normally open - normally open

Full eWelink application support!

Connect this device with your Sonoff ecosystem.

Possibility to select the channel state after the power returns - on, off, keep

Possibility to set a time loop, stopwatch in the application, After starting, switch the switch will automatically turn off after a specified period of time 1min-99h

Setting a schedule for up to 8 events per day

Setting a time loop

Possibility to set automation rules in the eWelink software. Create complex rules connecting more devices in the application.

Pairing with the eWelink application is the same as in the case of Sonoff devices. Our detailed pairing guide will give you step-by-step instructions. Operating modes: Jog (default) - momentary monostable mode, press the remote control button, the relay will turn on. Release the remote control button - the relay will turn off. Mode not supported by the application, in the application it works monostably - impulse.

Self-locking - bistable mode allows you to turn on devices that remain on until they are turned off Connected with another press of the remote control/application. The classic mode of action of transmission. nPRODUCT CODE: SE168R